Heated Oxygen Sensor (HO2S) consists of the zirconium and the
alumina and is installed on upstream and downstream of the Warm-up
Catalytic Converter (WCC).
After it compares oxygen consistency of the atmosphere with
the exhaust gas, it transfers the oxygen consistency of the exhaust gas
to the ECM. When A/F ratio is rich or lean, it generates approximately
1V or 0V respectively. In order that this sensor normally operates, the
temperature of the sensor tip is higher than 370°C (698°F). So it has a
heater which is controlled by the ECM duty signal.
When the exhaust gas temperature is lower than the specified value, the heater warms the sensor tip.
Removal
[Knock Sensor #1 (Bank 1)]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the knock sensor connector (A).
3.
Remove the intake man ...
Specification
[Bank 1 / sensor 2, Bank 2 / sensor 2]
A/F Ratio (?)Output Voltage(V)RICHMin. 0.8LEANMax. 0.1
ItemSpecificationHeater Resistance (?)3.3 ~ 4.1[20°C(68°F)]
[Bank 1 / sensor 1, ...
See also:
Front Seat Assembly Components and Components Location
Component Location
1. Front seat assembly
...
General Information
General
1.
Basically, all measurements in this manual are taken with a tracking gauge.
2.
When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
3.
...
Rear Body Body Repair
Roof panel rear cornerSide outer panel rear cornerRear package tray trim mounting hole (O12) Side outer panel rear cornerRear combination lamp mounting hole(8.5X8.5) Rear bumper mounting hole (14X ...