Hyundai Equus Manuals

Hyundai Azera: Rail Pressure Sensor (RPS) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Azera 2011-2024 Service ManualHyundai Azera: Rail Pressure Sensor (RPS) Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Engine Control/Fuel System / Engine Control System / Rail Pressure Sensor (RPS) Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
Condition
Output Voltage (V)
Idle
 Approx. 1.2
1,500 rpm
2.0 ~ 2.2
6,300 rpm
 Approx. 2.8

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”)
   
When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
3.
Remove the intake manifold.
4.
Disconnect the rail pressure sensor connector (A), and then remove the sensor from the delivery pipe.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Installation is reverse of removal.
Rail Pressure Sensor Installation:
29.4 ~ 34.3 N.m (3.0 ~ 3.5 kgf.m, 21.7 ~ 25.3 lb-ft)
Rail Pressure Sensor (RPS) Schematic Diagrams
Circuit Diagram ...

CVVT Oil Temperature Sensor (OTS) Description and Operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by ...

See also:

Tire Repair procedures
    • Using tires and wheel other than the recommended sizes could cause unusual handling characteristics and poor vehicle control, resulting in a serious accident. Tire We ...

Tilting the sunroof
When the sunshade is closed If you push the sunroof control lever upward, the sunshade will slide all the way open then the sunroof glass will tilt. To stop the sunroof movement at any point, p ...

Power windows
The ignition switch must be in the ON position for power windows to operate. Each door has a power window switch that controls the door's window. The driver’s door has a master power window swit ...

Categories

Hyundai Azera Manuals


© 2011-2024 Copyright www.hgmanual.com