Based on information from various sensors, the ECM can
calculate the fuel amount to be injected. The fuel injector is a
solenoid-operated valve and the fuel injection amount is controlled by
length of injection time. The ECM controls each injector by grounding
the control circuit. When the ECM energizes the injector by grounding
the control circuit, the circuit voltage should be low (theoretically
0V) and the fuel is injected. When the ECM de-energizes the injector by
opening control circuit, the fuel injector is closed and circuit voltage
should momentarily peak, and then settle at system voltage.
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification: Refer to "Specification"
Removal
1.
Turn the ignition swit ...
Specification
ItemSpecificationCoil Resistance (?)0.98 ~ 1.14 [20°C(68°F)]
...
See also:
Front Body Body Repair
Front Body A
Hood hinge mounting hole (O10)Fender panel mounting hole (O9)Front shock absorber mounting hole (O11)Cowl top cover mounting hole (O9)Roof panel front cornerFront pillar outer corne ...
Room Lamp Repair procedures
Removal
Room lamp(General type)
1.
Disconnect the negative(-) battery terminal.
2.
Remove the room lamp assembly (A) with (-) screwdriver.
3.
Remove the LED bulb (A).
Room lamp(Panoram ...
Certification label
The certification label is located on the driver's door sill at the center pillar.
This label shows the maximum allowable weight of the fully loaded vehicle.
This is called the GVWR (Gross V ...