Hyundai Equus Manuals

Hyundai Azera: CVVT Oil Control Valve (OCV) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Azera 2011-2024 Service ManualHyundai Azera: CVVT Oil Control Valve (OCV) Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Engine Control/Fuel System / Engine Control System / CVVT Oil Control Valve (OCV) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
[CVVT Oil Control Valve (Intake)]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the intake manifold.
3.
Disconnect the CVVT oil control valve connector (A).
4.
Remove the installation bolt (B), and then remove the valve from the engine.
[Bank 1]

[Bank 2]

[CVVT Oil Control Valve (Exhaust)]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the CVVT oil control valve connector (A).
[Bank 1]

[Bank 2]

3.
Remove the cylinder head cover.
4.
Remove the installation bolt (A), and then remove the valve from the engine.
[Bank 1]

[Bank 2]

Inatallation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
•
Apply the engine oil to the valve O-ring.
   
•
Exactly distinguish the color of the valve and harness connectors in bank 1 and 2 when installing, or the engine will operate abnormally (Refer to the table below).
Items
Component Side
Harness Side
Bank 1 (RH)
Grey
Bank 2 (LH)
Black

1.
Installation is reverse of removal.
CVVT oil control valve installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
CVVT Oil Control Valve (OCV) Schematic Diagrams
Circuit Diagram ...

Variable Intake Solenoid (VIS) Valve Description and Operation
Description Variable Intake manifold Solenoid (VIS) valves are installed on the intake manifold (VIS Valve 1) and the surge tank (VIS Valve 2). These VIS valve 1 and 2 control vacuum modulators ...

See also:

Instrument panel overview
1. Instrument cluster 2. Horn 3. Driver’s front air bag 4. Light control/Turn signals 5. Wiper/Washer 6. Steering wheel audio control 7. Cruise control switch 8. ENGINE START/STOP button ...

Sunglass holder
To open the sunglass holder, press the cover and the holder will slowly open. Place your sunglasses in the compartment door with the lenses facing out. Push to close. WARNING - Sunglass holder ...

Radiator Hose Components and Components Location
Components 1. Radiator upper hose2. Radiator lower hose3. Hose clip4. Clamp ...

Categories

Hyundai Azera Manuals


© 2011-2024 Copyright www.hgmanual.com