Inspection |
1. |
Turn the ignition switch OFF, and then remove battery (-) cable. |
2. |
Remove the fuel pump assembly. |
3. |
Check motor operation by fuel pump connector (A) connecting power (No.4) and ground (No.5).
|
1. |
Turn the ignition switch OFF, and then remove battery (-) cable. |
2. |
Remove the fuel pump assembly. |
3. |
Using an ohmmeter, measure the resistance between terminals 1 and 3 of sender connector (A) at each float level.
|
4. |
Also check that the resistance changes smoothly when the float is moved from "E" to "F".
|
Removal |
1. |
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”) |
2. |
Remove the fuel pump service cover (A) in the trunk. |
3. |
Disconnect the fuel pump connector (A) and the fuel tank pressure sensor connector (B). |
4. |
Disconnect the fuel feed tube quick connector (C). |
5. |
Remove the fuel pump plate cover (D) after removing the bolts. |
6. |
Remove the fuel pump from the fuel tank. |
Installation |
1. |
Installation is reverse of removal.
|
Calling by Dialing a Number
Press the key
Select [Dial Number]
1) Dial Pad : Used to enter phone number
2) Call : If a number has been entered, calls the number If no number has been entered,
switches to call history scre ...
Side Body Body Repair
Side Body A
Front side member tooling hole (O20)Fender apron upper member tooling hole (O10) Front door upper hinge mounting hole(O13) Front door lower hinge mounting hole (O13) Rear door upper h ...
Defroster
CAUTION - Conductors
To prevent damage to the conductors bonded to the inside surface of the rear
window, never use sharp instruments or window cleaners containing abrasives to clean
the window.
& ...