Hyundai Azera: Filler-Neck Assembly Repair procedures
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Engine Control/Fuel System / Fuel Delivery System / Filler-Neck Assembly Repair procedures
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Engine Control/Fuel System / Fuel Delivery System / Filler-Neck Assembly Repair procedures
| Removal |
| 1. |
Lift the vehicle. |
| 2. |
Disconnect the fuel filler hose (A). |
| 3. |
Disconnect the ventilation hose (B) from the fuel tank air filter.
|
| 4. |
Open the fuel filler door and then remove the filler-neck installation screw (A).
|
| 5. |
Remove the rear-LH wheel, tire, and the inner wheel house (A).
|
| 6. |
Remove the filler-neck assembly from the vehicle after removing the bracket installation bolt (A).
|
| Installation |
| 1. |
Installation is reverse of removal.
|
Fuel Line Repair procedures
Removal
In case of removing the high pressure fuel pump, high
pressure fuel pipe, delivery pipe, and injector, there may be injury
caused by leakage of the high pressure f ...
Accelerator Pedal Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).
3.
Remove the installation nuts (B) and ...
See also:
Main Crash Pad Assembly Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
Take ...
Components and Components Location
Component
1. Driver airbag (DAB)2. Remote control assembly3. Steering wheel body4. Wiring5. Lower cover
...
Rear Console Cover Components and Components Location
Component Location
1. Rear console cover
...
Categories
Hyundai Azera Manuals
© 2011-2024 Copyright www.hgmanual.com