Removal |
In case of removing the high pressure fuel pump, high
pressure fuel pipe, delivery pipe, and injector, there may be injury
caused by leakage of the high pressure fuel. So don’t do any repair
work right after engine stops.
|
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”)
|
3. |
Remove the pump foam (A). |
4. |
Disconnect the fuel pressure control valve connector (A) and the fuel feed tube quick-connector (B). |
5. |
Remove the intake manifold.
|
6. |
Remove the injector foam (A). |
7. |
Remove the high pressure fuel pipe.
|
8. |
Remove the installation bolts (A), and then remove the high pressure fuel pump (B) from the cylinder head assembly.
|
Installation |
|
|
|
|
|
|
|
|
1. |
Installation is reverse of removal.
|
Canister Close Valve (CCV) Schematic Diagrams
Circuit Diagram
...
Active ECO operation
Active ECO helps improve fuel efficiency by controlling certain engine and transaxle
system operating parameters. Fuel efficiency depends on the driver's driving habit
and road condition.
Wh ...
Headlight (Headlamp) escort function
If you turn the ignition switch to the ACC or OFF position with the headlights
ON, the headlights (and/or parking light) remain on for about 5 minutes. However,
if the driver’s door is opened and cl ...