Removal and Installation |
1. |
Remove the radiator upper hose and lower hose.
|
2. |
Remove the cooling fan assembly.
|
3. |
Disconnect the over flow hose.
|
4. |
Disconnect the hose (B) after removing the automatic transaxle fluid cooler hose clamp (A). |
5. |
Remove the radiator mounting brackets (A).
|
6. |
Separate the condenser from the radiator and then pull radiator (A) up and remove it from engine room. |
7. |
Installation is in the reverse order of removal. |
8. |
Fill the radiator with coolant and check for leaks.
|
Inspection |
1. |
Remove the radiator cap, wet its seal with engine coolant, and then install it on a pressure tester. |
2. |
Apply a pressure of 93.16 ~ 122.58kpa (0.95 ~ 1.25kg/cm?, 13.51 ~ 17.78psi). |
3. |
Check for a drop in pressure. |
4. |
If the pressure drops, replace the cap. |
1. |
Wait until engine is cool, then carefully remove the radiator
cap and fill the radiator with engine coolant, then install it on the
pressure tester. |
2. |
Apply a pressure tester to the radiator and apply a pressure of 93.16 ~ 122.58kpa (0.95 ~ 1.25kg/cm?, 13.51 ~ 17.78psi). |
3. |
Inspect for engine coolant leaks and a drop in pressure. |
4. |
Remove the tester and reinstall the radiator cap.
|
Hands Free Mic Repair procedures
Inspection
1.
Disconnect the negative(-) battery terminal.
2.
Remove the roof trim.
(Refer to Body - "Roof Trim Assembly")
3.
Remove the handsfree mic (A) after disconnect the connector f ...
ETC (Electronic Throttle Control) System Troubleshooting
Fail-Safe Mode
ItemFail-SafeETC MotorThrottle valve stuck at 7°TPSTPS 1 faultECM looks at TPS2TPS 2 faultECM looks at TPS1TPS 1,2 faultThrottle valve stuck at 7°APSAPS 1 faultECM looks at APS 2AP ...
Troubleshooting
Troubleshooting
Ignition System
SymptomSuspect areaRemedyEngine will not start or is hard to start (Cranks OK)Ignition lock switchInspect ignition lock switch, or replace as requiredIgnition coilI ...