Service Adjustment Procedure |
Oil level Check |
A check of Automatic Transaxle Fluid(ATF) level is not
normally required during scheduled services. If an oil leak is found,
perform the oil level check procedure after repairs are completed. |
When checking the oil level, be careful not to enter dust, foreign matters, etc. from fill hole.
|
1. |
Remove the eyebolt (A).
|
2. |
Add ATF SP-IV 700cc to the ATF injection hole. |
3. |
Start the engine. (Don’t step on brake and accelerator simultaneously.) |
4. |
Confirm that the temperature of the Automatic Transaxle(AT) Oil Temperature Sensor(OTS) is 50~60°C(122~140°F) with the GDS. |
5. |
Shift the select lever slowly from “P” to “D”, then “D” to “P” and repeat one more at idle.
|
6. |
Lift the vehicle, then remove the oil level plug (A) from the valve body cover.
|
7. |
If the oil flows out of the overflow plug in thin steady stream, the oil level is correct.
Then finish the procedure and tighten the oil plug.
|
8. |
Put down the vehicle with the lift and then tighten the eyebolt. |
Replacement |
ATF of the 6-speed automatic transaxle does not need to be
replaced for Normal Usage. If the vehicle is used for any of the Severe
Usage conditions listed below, replace the ATF every 60,000 miles.
|
1. |
Remove the drain plug (A) and drain the ATF totally. Reinstall the drain plug.
|
2. |
Fill the oil about 5 liters through eyebolt. |
3. |
Check the oil level.
(Refer to Hydraulic System - "Fluid") |
Engine And Transmission Assembly Repair procedures
Removal
•
Use fender covers to avoid damaging painted surfaces.
•
To avoid damage, unplug the wiring connectors carefully while holding the connector portion.
...
Map lamp
,
Push the switch (1) to turn the map lamp on or off. This light produces a spot
beam for convenient use as a map lamp at night or as a personal lamp for the driver
and the fro ...
Automatic heating and air conditioning
1. Push the AUTO button.
The modes, fan speeds, air intake and air-conditioning will be controlled automatically
by setting the temperature.
2. Set the temperature to the desired temperatur ...