Removal |
1. |
Remove the battery and the battery tray.
|
2. |
Remove the under cover (A).
|
3. |
Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug.
(Refer to Hydraulic System - "Fluid") |
4. |
Remove the valve body cover (B) and eyebolt (A).
|
5. |
Remove the bolt (3ea) after disconnecting the solenoid valve connector (B) and the oil temperature sensor connector (A).
|
6. |
Remove the valve body assembly (A).
|
Installation |
1. |
Installation is the reverse of removal. |
After replacement or reinstallation procedure of the valve body assembly, must perform procedures below. |
|
Smart Cruise Control Switch Schematic Diagrams
Circuit Diagram
...
Engine number
The engine number is stamped on the engine block as shown in the drawing. ...
Mode Control Actuator Components and Components Location
Component Location
...