Inspection |
1. |
Turn ignition switch OFF. |
2. |
Disconnect the solenoid valve connector. |
3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
4. |
Check that the resistance is within the specification.
|
Removal |
1. |
Remove the battery and the battery tray.
|
2. |
Remove the under cover (A).
|
3. |
Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug.
(Refer to Hydraulic System - "Fluid") |
4. |
Remove the valve body cover (B) and eyebolt (A).
|
5. |
Disconnect the oil temperature sensor connector (A). |
6. |
Remove the oil temperature sensor (A) after removing a bolt.
|
Installation |
1. |
Installation is the reverse of removal. |
After replacement or reinstallation procedure of the oil temperature sensor, must perform procedures below.
|
Components and Components Location
Component Location
1. Windshield deicer relay (Built-in engine room relay box)2. Windshield deicer switch (Rear glass defogger switch)3. Windshield deicer4. Deicer connector
...
Engine Cover Components and Components Location
Components Location
1. Engine cover
...
In-car sensor Description and Operation
Description
1.
In-car air temperature sensor is located at the lower crash pad.
2.
The sensor contains a thermistor which measures the
temperature of the cabin. The signal, determined by the ...