Input speed sensor is a vital unit that measures the rate of
rotation of the input shaft inside the transaxle and delivers the
readings to the Transaxle Control Module(TCM). The sensor provides
critical input data that's used in feedback control, damper clutch
control, gear setting control, line pressure control, clutch activation
pressure control, and sensor fault analysis.
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Specifications
? Type: Hall effect sensor
Operation condition [°C(°F)](-40~150) -40~302Air gap(mm)in.(0.95~1.65)0.037~0.065Output voltage(V)High1.18~1.68Low0.59~0.84
...
See also:
Rear combination light bulb replacement
(1) Stop and tail light
(2) Rear turn signal light
(3) Backup light
(4) Rear side marker
Stop/tail light and rear side marker
If the light bulb does not operate, have the vehicle checked by an ...
Active ECO system
...
Transmitter Specifications
Specification
ItemDescriptionPower source3VOperating temperature-20°C ~ +60°CRF ModulationFSKRF frequency433.92MHzBattery1EA (CR2032)
An inappropriately disposed battery ca ...