Inspection |
1. |
Check signal waveform of Input & output speed sensor using the GDS.
|
Removal |
1. |
Remove the battery and the battery tray.
|
2. |
Remove the under cover (A).
|
3. |
Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug.
(Refer to Hydraulic System - "Fluid") |
4. |
Remove the valve body cover (B) and eyebolt (A).
|
5. |
Remove the plate and the detent spring (A) after removing the bolt.
|
6. |
Remove the bolt (3ea) after disconnecting the solenoid valve connector (A) and the oil temperature sensor connector (B).
|
7. |
Remove the valve body assembly (A).
|
8. |
Disconnect the input & output speed sensor connector(A). |
9. |
Remove the input & output speed sensor (B) after removing the bolts(2ea).
|
Installation |
1. |
Installation is the reverse of removal. |
After replacement or reinstallation procedure of the input speed sensor, must perform procedures below.
|
Shift Lever Repair procedures
Removal
1.
Remove the center console assembly.
(Refer to Body - "Console")
2.
Remove the duct (A).
3.
Disconnect sports mode connector (A).
4.
Remove the shift cable (B).
5.
Remo ...
Engine compartment
1. Engine oil dipstick
2. Engine oil filler cap
3. Engine coolant reservoir
4. Radiator cap
5. Brake fluid reservoir
6. Windshield washer fluid reservoir
7. Air cleaner
8. Positive battery te ...
Steering Angle Sensor Description and Operation
Description
The Steering Angle Sensor (SAS) is installed in MDPS (Motor
Driven Power Steering) and it sends messages to HECU through CAN
communication line.
The SAS is used to determine turnin ...