Inspection |
1. |
Turn ignition switch OFF. |
2. |
Disconnect the solenoid valve connector. |
3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
4. |
Check that the resistance is within the specification. |
Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to Hydraulic System - "Valve Body") |
Saving Presets
After selecting the channel Press
and hold the desired preset ~
key.
A 'beep' will sound and the channel is saved to the selected preset button. ...
Side Body Body Repair
Side Body A
Front side member tooling hole (O20)Fender apron upper member tooling hole (O10) Front door upper hinge mounting hole(O13) Front door lower hinge mounting hole (O13) Rear door upper h ...
Main Muffler Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal.
(Refer to Engine Electrical System - "Battery")
2.
Remove the main muffler (A).
Tightening torque:
39.2 ~ 58.8 N.m ( ...