Inspection |
|
1. |
Inspect DTC code. |
2. |
Inspect whether N setting matches.
|
3. |
Inspect shift cable separation.
|
4. |
Inspect whether connector is connected.
|
5. |
Inspect ground condition on reversing light circuit.
|
6. |
Inspect wiring connection on junction box power terminal and fuse lamp.
|
7. |
Inspect inhibitor switch signal.
|
Removal |
1. |
Make sure vehicle does not roll before setting room side
shift lever and Automatic Transaxle(AT) side manual control lever to "N"
position. |
2. |
Remove the battery and the battery tray.
|
3. |
Remove the air cleaner assembly.
|
4. |
Remove the shift cable mounting nut (B).
|
5. |
Disconnect the inhibitor switch connector (A). |
6. |
Remove the manual control lever (B) and the washer after removing a nut (A).
|
7. |
Remove the inhibitor assembly (A) after removing the bolts (2ea).
|
Installation |
1. |
Installation is the reverse of removal. |
Output Speed Sensor Description and Operation
Description
The output speed sensor is a vital unit that measures the
rate of rotation of the transaxle's turbine shaft and output shaft, and
delivers the readings to the Transaxle Control Modu ...
Oil Cooler Repair procedures
Removal and Installation
1.
Remove the radiator upper hose and lower hose.
(Refer to Engine Mechanical System - "Radiator Hose")
2.
Remove the cooling fan assembly.
(Refer to Engine Mechani ...
Checking the washer fluid level
Check the fluid level in the washer fluid reservoir and add fluid if necessary.
Plain water may be used if washer fluid is not available. However, use washer solvent
with antifreeze characteristics ...