Replacement |
1. |
Loosen the wheel lug nuts slightly.
Raise the vehicle, and make sure it is securely supported. |
2. |
Remove the front wheel and tire(A) from front hub.
|
3. |
Loosen the wheel speed sensor mount bolt and then remove the wheel speed sensor(A) from the knuckle.
|
4. |
Remove the brake caliper mounting bolts , and then place the brake caliper assembly(A) with wire.
|
5. |
Remove the tie rod end ball joint(A) from the knuckle.
|
6. |
Remove driveshaft coking nut(A) from the front hub under applying the brake.
|
7. |
Remove the lower arm(A) from the knuckle.
|
8. |
Disconnect the driveshaft(A) from the front hub assembly.
|
9. |
Loosen the strut bolts and nuts and then remove the kunckle assembly(A).
|
Disassembly |
1. |
Remove the snap ring(A). |
2. |
Remove the hub assembly from the knuckle assembly.
|
3. |
Remove the hub bearing inner race from the hub assembly.
|
4. |
Remove the hub bearing outer race from the knuckle assembly.
|
5. |
Replace hub bearing with a new one.
|
Reassembly |
1. |
Install the hub bearing to the knuckle assembly.
|
2. |
Install the hub assembly to the knuckle assembly.
|
3. |
Install the snap ring(A). |
Inspection |
1. |
Check the hub for cracks and the splines for wear. |
2. |
Check the brake disc for scoring and damage. |
3. |
Check the knuckle for cracks. |
4. |
Check the bearing for cracks or damage. |
Installation |
1. |
Install in the reverse order of removal.
|
Intake Actuator Components and Components Location
Component Location
...
Daytime running light
Daytime Running Lights (DRL) can make it easier for others to see the front of
your vehicle during the day. DRL can be helpful in many different driving conditions,
and it is especially helpful afte ...
Front Oil Seal Repair procedures
Removal
1.
Remove the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Damper Pulley")
2.
Remove the front oil seal (A).
Installation
1.
Using SST(09231-3C100), install t ...