Replacement |
|
1. |
Remove the Front Driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”) |
2. |
Remove the circlip (B) from the driveshaft spline (A). |
3. |
Remove both boot bands from the TJ case. |
4. |
Remove the TJ case (A).
|
5. |
Remove the snap ring (A) from the shaft. |
6. |
Remove the spider assembly (B) from the driveshaft (A) using the special tool (09495-33000). |
7. |
Clean the spider assembly. |
8. |
Remove the TJ boot (A).
|
Inspection |
1. |
Check the spider assembly for roller rotation, wear or corrosion. |
2. |
Check the groove inside the joint case for wear or corrosion |
3. |
Check the TJ boots for damage and deterioration. |
Installation |
1. |
Wrap tape around the driveshaft spline(TJ) to prevent damage to the boot. |
2. |
Using the alignment marks (D) made during disassembly as a
guide, install the spider assembly (A) and snap ring (B) on the
driveshaft splines (C). |
3. |
Add specified grease to the joint boot as much as it was wiped away at inspection. |
4. |
Install the both boot band. |
5. |
To control the air in the TJ boot, keep the specified distance between the boot bands when they are tightened.
|
6. |
Using the SST(09495-3K000), secure the TJ boot bands.
|
7. |
Install the Front Driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”) |
Glove box
The glove box can be locked and unlocked with the mechanical key (1).
To open the glove box, push the button (2) and the glove box will automatically
open. Close the glove box after use.
WARNIN ...
Rear Seat Belt Buckle Components and Components Location
Component Location
1. Rear seat belt buckle [LH]2. Rear seat belt buckle [RH]
...
Components and Components Location
Component Location
1. Driver power window main switch2. Passenger power window switch3. Front window motor4. Rear window motor5. Rear window switch
...