Replacement |
1. |
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”) |
2. |
Remove the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ Joint”) |
3. |
Using a pillar or flat-tipped(-) screwdriver, remove the both side of clamp(B) of the dynamic damper(A). |
4. |
Fix the driveshaft (A) with a vice (B) as illustrated. |
5. |
Apply soap powder on the shaft to prevent being damaged
between the shaft spline and the dynamic damper when the dynamic damper
is removed. |
6. |
Seperate the dynamic damper (A) from the shaft (B) carefully. |
Installation |
1. |
Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper. |
2. |
Install the dynamic damper (A). |
3. |
Using the SST(09495-3K000), secure the dynamic damper bands (B). |
4. |
Install the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ Joint”) |
5. |
Install the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”) |
Fuel Filter Repair procedures
Removal
1.
Remove the fuel pump.
(Refer to Fuel Delivery System - “Fuel Pump”)
2.
Disconnect the electric pump wiring connector (A) and the fuel sender connector (B).
3.
Remove the cushi ...
Compressor Repair procedures
Removal
1.
If the compressor is marginally operable, run the engine at
idle speed, and let the air conditioning work for a few minutes, then
shut the engine off.
2.
Disconnect the negati ...
Fuel Tank Pressure Sensor (FTPS) Specifications
Specification
Pressure [kPa (kgf/cm?, psi)]Output Voltage (V)-6.67 (-0.06, -0.97)0.502.5+6.67 (0.068, 0.97)4.5
...