Hyundai Equus Manuals

Hyundai Azera: BJ Boot Repair procedures - Driveshaft Assembly - Driveshaft and axle - Hyundai Azera 2011-2024 Service ManualHyundai Azera: BJ Boot Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Driveshaft and axle / Driveshaft Assembly / BJ Boot Repair procedures

Replacement
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ Joint”)
3.
Remove the dynamic damper.
(Refer to Driveshaft Assembly - "Dynamic Damper")
4.
Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).

5.
Remove the BJ boot.
6.
Install in the reverse order of removal.
   
•
Do not disassemble the BJ assembly.
•
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
•
The boot band should be replaced with a new one.
BJ Boot Components and Components Location
Components [LH] 1. BJ assembly2. Circlip3. BJ boot band4. BJ boot 5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band 9. TJ boot10. Spider assembly11. Snap ring12. TJ case 13. Circl ...

Rear Axle Assembly
...

See also:

IMS Power Seat Control Schematic Diagrams
Circuit diagram ...

Turn by Turn
The Turn by Turn feature can be used through Blue Link®. (1) Direction Indicator Image (2) Remaining distance until next point (3) The Count bar is divided into a total of 9 levels. (4) Next S ...

ETC (Electronic Throttle Control) System Schematic Diagrams
Circuit Diagram ...

Categories

Hyundai Azera Manuals


© 2011-2024 Copyright www.hgmanual.com