Replacement |
1. |
Loosen the wheel lug nuts slightly.
Raise the vehicle, and make sure it is securely supported. |
2. |
Remove the rear wheel and tire (A) from front hub.
|
3. |
Loosen the bolt & nut and then disconnect the shock absorber (A) with the rear axle.
|
4. |
Loosen the rear upper arm bolts and nut and then remove the rear upper arm (A).
|
5. |
Disconnect the parking brake connector (A). |
6. |
Remove the brake caliper mounting bolts, and then hold the brake caliper assembly (A) with wire.
|
7. |
Loosen the disc mount screw and then brake disc (A).
|
8. |
Remove the wheel speed sensor (A) and brake hose.
|
9. |
Loosen the hub bearing mounting, and then remove the hub bearing (A) from knuckle.
|
10. |
Loosen the assist arm mounting nut and then remove the assist arm (A).
|
11. |
Loosen the trailing arm mounting nuts, and then remove the trailing arm (A),
|
12. |
Loosen the lower arm mounting bolt and nut and then remove the rear hub assembly (A).
|
Inspection |
1. |
Check the hub for cracks and the splines for wear. |
2. |
Check the brake disc for scoring and damage. |
3. |
Check the rear axle carrier for cracks. |
4. |
Check the bearing for cracks or damage.
|
Installation |
1. |
Installation is the reverse of removal.
|
Smart key receiver Repair procedures
Removal
RF Receiver
-
Take care not to scratch the crash pad and related parts
1.
Disconnect the negative(-) battery terminal.
2.
Remove the rear seat.
(Refer to ...
Front Seat Cushion Cover Repair procedures
Replacement
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and pan ...
Repair procedures
General Inspection
After or before servicing the EPS system, perform the
troubleshooting and test procedure as follows. Compare the system
condition with normal condition in the table below and ...