Replacement |
1. |
Remove the front wheel & tire (A).
|
2. |
Loosen the bolt (A) and then disconnect the universal joint assembly from the pinion of the steering gear box.
|
3. |
Remove the under cover (A). |
4. |
Remove the sprit pin and castle nut and then disconnect the tie-rod end (A) from the front knuckle.
|
5. |
Loosen the bolt & nut and then remove the lower arm (A).
|
6. |
Disconnect the stabilizer link (B) with the front strut assembly (A) after loosening the nut.
|
7. |
Loosen the bolt and then remove the front roll stopper (A).
|
8. |
Disconnect the muffler rubber hanger (A). |
9. |
Loosen the bolts & nuts and then remove the sub frame (A).
|
10. |
Remove the front lower arm.
(Refer to Front Suspension System - "Front Lower Arm") |
11. |
Remove the front strut assembly.
(Refer to Front Suspension System - "Front Strut Assembly") |
12. |
Remove the front stabilizer bar.
(Refer to Front Suspension System - "Front Stabilizer Bar") |
13. |
Remove the steering gear box.
|
14. |
Installation is the reverse of removal. |
15. |
Check the alignment.
(Refer to Tires/Wheels - "Alingnent") |
High mounted stop light replacement
If the light bulb does not operate, have the vehicle be checked by an authorized
HYUNDAI dealer.
A skilled technician should check or repair the high mounted stop light. Otherwise,
it may affect ...
Engine Mounting Repair procedures
Removal and Installation
[Engine mounting support bracket]
1.
Install the jack to the edge of upper oil pan (A) to support the engine.
Insert the rubber block between jac ...
Transmitter Repair procedures
Inspection
1.
Check that the red light flickers when the door lock or unlock button is pressed on the transmitter.
2.
Remove the battery (A) and check voltage if the red light doesn't flicker. ...