Hyundai Equus Manuals

Hyundai Azera: Rear Lower Arm Repair procedures - Rear Suspension System - Suspension System - Hyundai Azera 2011-2024 Service ManualHyundai Azera: Rear Lower Arm Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Suspension System / Rear Suspension System / Rear Lower Arm Repair procedures

Removal
1.
Remove the rear wheel & tire (A).
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

   
•
Be careful not to damage to the hub bolts when removing the front wheel & tire.
2.
Set up the transmission jack (A) under the lower arm (B).

3.
Loosen the nut and then remove the rear stabilizer link (A) from the lower arm and subframe.
Tightening torque:
98.1 ~ 117.7N.m (10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

4.
Loosen the bolt & nut and then remove the rear lower arm (A) with the rear axle.
Tightening torque:
137.3~156.9N.m(14.0~16.0Kgf.m, 101.3~115.7lb-ft)
   
•
When removing the bolt, remove the upper arm in no-load condition by using the transmission jack.

5.
Loosen the bolt & nut and then remove the rear lower arm (A) from the sub frame.
Tightening torque:
107.9~117.7N.m(11.0~12.0Kgf.m, 79.6~86.8lb-ft)
   
•
When removing the bolt, remove the lower arm in no-load condition by using the transmission jack.

Installation
1.
Installation is the reverse of removal.
   
•
If you don't install the jack, the bolt may cut due to the high work load of lower arm mounting bolt.
•
Install the component with the specified torques.
•
When installing the bolt, install the lower arm in no-load condition by using the transmission jack.
Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the rear lower arm for deformation.
3.
Check for all bolts and nut.
4.
Check the cracks or the cutting of the lower arm.
Rear Upper Arm Repair procedures
Removal 1. Remove the rear wheel & tire (A). Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage to the hub bolts when ...

Rear Stabilizer Bar Repair procedures
Replacement 1. Remove the rear wheel & tire (A). Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     • Be careful not to damage to the hub bo ...

See also:

Front Seat Shield Inner Cover Repair procedures
Replacement     • Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface. • Take care not to bend or scratch the trim and pan ...

Fuel Shut Off Valve Repair procedures
Removal 1. Lift the vehicle and support the fuel tank with a jack. 2. Remove the nuts (A) from fuel tank. 3. Disconnect the fuel filler hose (A). 4. Remove the fuel shut off valve (A). ...

Description and Operation
Description The hydraulic system consists of oil, an oil filter, an oil pump, and a valve body (valves and solenoid valves). The oil pump is powered by the engine. ATF passes through the oil fi ...

Categories

Hyundai Azera Manuals


© 2011-2024 Copyright www.hgmanual.com