Hyundai Azera: Wheel Repair procedures
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Suspension System / Tires/Wheels / Wheel Repair procedures
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Suspension System / Tires/Wheels / Wheel Repair procedures
| Lug nut tightening sequence |
Tighten the hub nuts as follows.
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) |
When using an impact gun, final tightening torque should be checked using a torque wrench. |
Run out inspection
| 1. |
Jack up the vehicle. |
| 2. |
Measure the wheel Run-out by using a dial indicator as illustration below.
| ||||||||||||
| 3. |
If measured value exceeds the standard value, replace the wheel.
|
Tire Repair procedures
•
Using tires and wheel other than the recommended sizes could
cause unusual handling characteristics and poor vehicle control,
resulting in a serious accident.
Tire We ...
Alignment Repair procedures
Front Wheel Alignment
When using a commercially available computerized wheel
alignment equipment to inspect the front wheel alignment, always
position the vehicle on a lev ...
See also:
Rear seat
Headrest
The rear seat is equipped with headrests for the occupant's safety and comfort.
The headrest not only provides comfort for passengers, but also helps to protect
the head and neck i ...
Description and Operation
Description
The starting system includes the battery, starter, solenoid
switch, ignition switch, inhibitor switch (A/T), clutch pedal switch
(M/T), ignition lock switch, connection wires and th ...
Thermostat Components and Components Location
Components
1. Water temperature control assembly2. Thermostat3. Water inlet fitting
...
Categories
Hyundai Azera Manuals
© 2011-2024 Copyright www.hgmanual.com