Removal |
1. |
Remove the tire.
(Refer to Tires/Wheels - "Tire") |
2. |
Remove the valve nut.
|
Installation |
|
1. |
Assemble valve to sensor and turn valve 3 times with the square part of the screw in the slot.
|
2. |
Mount assembly to wheel.
|
3. |
Tighten washer and nut by hand until the valve thread meets the nut built-in calibrated stop.
|
4. |
Using a torque wrench, tighten the nut to 2.95±0.37 lb-ft
(4.0±0.5 Nm) It is normal to feel a break as the 1.7 lb-ft (2.3Nm)
calibrated stop in the nut snaps and the torque falls. |
|
Sensor ID Writing (Wireless) |
Sensor ID Writing |
Gauges
Speedometer
The speedometer indicates the vehicle speed.
The speedometer is calibrated in miles per hour and/or kilometers per hour.
Tachometer
The tachometer indicates the engine speed in rev ...
Brake Booster Repair procedures
Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following tests.
1.
Run the engine for one or two minutes, and then stop it. If
the pedal depress ...
Air cleaner
...