Replacement |
1. |
Remove the front wheel & tire (A).
|
2. |
Loosen the bolt (A) and then disconnect the universal joint assembly from the pinion of the steering gear box.
|
3. |
Remove the under cover (A). |
4. |
Remove the sprit pin and castle nut and then disconnect the tie-rod end (A) from the front knuckle.
|
5. |
Loosen the bolt & nut and then remove the lower arm (A).
|
6. |
Disconnect the stabilizer link (B) with the front strut assembly (A) after loosening the nut.
|
7. |
Loosen the bolt and then remove the front roll stopper (A).
|
8. |
Disconnect the muffler rubber hanger (A). |
9. |
Loosen the bolts & nuts and then remove the sub frame (A).
|
10. |
Remove the stabilizer bar (A).
|
11. |
Remove steering gear box (A) from the front sub frame by loosening the mounting bolts.
|
12. |
Installation is the reverse of removal. |
13. |
Check the alignment.
|
Roof Side Molding Repair procedures
Replacement
[General Type]
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent dama ...
Checking the engine oil level
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil
to ...
Rear parking assist system OFF button
To turn off the rear parking assist system, push the button (the indicator light
will illuminate). ...