Component Replacement After Deployment |
Before doing any SRS repairs, use the GDS to check for DTCs.
Refer to the Diagnostic Trouble Code list for repairing of the related
DTCs. |
- |
SRSCM |
- |
Deployed airbag(s) |
- |
Seat belt pretensioner(s) |
- |
Front impact sensors |
- |
SRS wiring harnesses |
- |
Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
|
- |
SRSCM |
- |
Deployed airbag(s) |
- |
Side impact sensor(s) for the deployed side(s) |
- |
SRS wiring harnesses
|
- |
Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off. |
Line Pressure Control Solenoid Valve Schematic Diagrams
Circuit Diagram
...
Ignition Coil Repair procedures
Removal and Installation
[LH]
1.
Disconnect the battery nagative terminal.
2.
Remove the engine cover.
3.
Disconnect the LH ignition coil connectors (A) and then remove the LH ignition ...
Thermostat Components and Components Location
Components
1. Water temperature control assembly2. Thermostat3. Water inlet fitting
...