The primary purpose of the SRSCM (Supplemental Restraints
System Control Module) is to discriminate between an event that warrants
restraint system deployment and an event that does not. The SRSCM must
decide whether to deploy the restraint system or not. After determining
that pretensioners and/or airbag deployment is required, the SRSCM must
supply sufficient power to the pretensioners and airbag igniters to
initiate deployment.
The SRSCM determines that an impact may require deployment of
the pretensioners and airbags from data obtained from impact sensors
and other components in conjunction with a safing function.
The SRSCM will not be ready to detect a crash or to activate
the restraint system devices until the signals in the SRSCM circuitry
stabilize.
It is possible that the SRSCM could activate the safety
restraint devices in approximately 2 seconds but is guaranteed to fully
function after prove-out is completed.
The SRSCM must perform a diagnostic routine and light a
system readiness indicator at key-on. The system must perform a
continuous diagnostic routine and provide fault annunciation through a
warning lamp indicator in the event of fault detection. A serial
diagnostic communication interface will be used to facilitate servicing
of the restraint control system.
See also:
Glove box
The glove box can be locked and unlocked with the mechanical key (1).
To open the glove box, push the button (2) and the glove box will automatically
open. Close the glove box after use.
WARNIN ...
Oil Pump Description and Operation
Description
The oil pump is built-in as a single unit with the 26 Brake
chamber. Rotation of the pump builds the hydraulic pressure needed for
the lubrication of the various parts of the transa ...
Tire sidewall labeling
This information identifies and describes the fundamental characteristics of
the tire and also provides the tire identification number (TIN) for safety standard
certification. The TIN can be used ...