Removal |
1. |
Disconnect the battery negative cable and wait for at least three minutes before beginning work. |
2. |
Remove the crash pad lower panel.
|
3. |
After loosening the mounting nuts and then remove the knee airbag (A). |
4. |
Disconnect the knee airbag harness connector (A). |
Installation |
1. |
Remove the ignition key from the vehicle. |
2. |
Disconnect the battery negative cable and wait for at least three minutes. |
3. |
Connect the knee airbag connector. |
4. |
Tighten the knee airbag mounting nuts.
|
5. |
Install the crash pad lower panel.
|
6. |
Install the crash pad side cover.
|
7. |
Reconnect the battery negative cable. |
8. |
After installing the knee airbag, confirm proper system operation:
|
Input Speed Sensor Troubleshooting
Signal Waveform
Fig 1) Input/Output speed sensor at low speed
Fig 2) Input/Output speed sensor at high speed ...
Outside rearview mirror
Be sure to adjust mirror angles before driving.
Your vehicle is equipped with both left-hand and right-hand outside rearview
mirrors. The mirrors can be adjusted remotely with the remote switch. The ...
Ignition Coil Components and Components Location
Components
1. Condensor2. Bracket3. Ignition coil4. Ignition coil harness
...