Removal |
1. |
Turm ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Remove the air duct (B) and air cleaner assembly (A). |
3. |
Disconnect the brake fluid level switch connector (B), and remove the reservoir cap. |
4. |
Remove the brake fluid from the master cylinder reservoir with a syringe.
|
5. |
Disconnect the brake tube (A) from the master cylinder by loosening the tube flare nut.
|
6. |
Remove the master cylinder (B) from the brake booster after loosening the mounting nuts (A).
|
Installation |
1. |
Installation is the reverse of removal. |
2. |
After installation, bleed the brake system.
(Refer to Brake system bleeding) |
Radial-ply tires
Radial-ply tires provide improved tread life, road hazard resistance and smoother
high speed ride. The radial- ply tires used on this vehicle are of belted construction,
and are selected to compleme ...
Wheel alignment and tire balance
The wheels on your vehicle were aligned and balanced carefully at the factory
to give you the longest tire life and best overall performance.
In most cases, you will not need to have your wheels ali ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Schematic Diagrams
Circuit Diagram
...