Removal |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Remove the crash pad lower panel.
|
3. |
Remove the junction box.
|
4. |
Disconnect the parking brake switch connector (A). |
5. |
Remove the parking brake cable mounting nuts (A). |
6. |
Remove the parking brake pedal mounting bolts (A) and nut (B). |
7. |
Remove the parking brake cable adjusting nut(A) and the fixing clip(B), and then remove the parking brake pedal. |
Installation |
1. |
Install the holding clip (B) and the cable adjusting nut(A) after fixing the parking brake cable. |
2. |
Install the parking brake pedal, and then install the parking brake pedal mounting bolts (A) and nuts (B).
|
3. |
Adjust the parking brake pedal stroke by turning the adjusting nut (A).
|
4. |
Reconnect the parking brake switch connector (A). |
5. |
Install the juncting box.
|
6. |
Install the crash pad lower panel.
|
Adjustment |
1. |
Operate the parking brake pedal through a full stroke over 3 times for setting the parking cables. |
2. |
Adjust the adjusting nut(A) for parking barke pedal stoke 4~5 notches when operating effort is 196N(20kgf, 44lbf)
|
Rear Shock Absorber Repair procedures
Replacement
1.
Remove the rear wheel & tire (A).
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
Be careful not to damage to the hub bolts w ...
Fuel Tank Pressure Sensor (FTPS) Description and Operation
Description
Fuel Tank Pressure Sensor (FTPS) is a component of the
evaporative emission control system and is installed on the fuel tank,
the fuel pump, or the canister. It checks the purge con ...
Ignition Coil Repair procedures
Removal and Installation
[LH]
1.
Disconnect the battery nagative terminal.
2.
Remove the engine cover.
3.
Disconnect the LH ignition coil connectors (A) and then remove the LH ignition ...