Hyundai Equus Manuals

Hyundai Azera: Rear Wheel Speed Sensor Repair procedures - ESC(Electronic Stability Control) System - Brake System - Hyundai Azera 2011-2024 Service ManualHyundai Azera: Rear Wheel Speed Sensor Repair procedures

Removal
1.
Remove the rear wheel and tire.

Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

2.
Remove the rear wheel speed sensor mounting bolt (A).

Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 7.6 lb-ft)

3.
Remove the rear seat back.
4.
Disconnect the rear wheel speed sensor connector.
5.
Installation is the reverse of removal.
   
Install the rear sensor after lubricating the O-ring of sensor with the assembly fluid(RAREMAX AF-1).
When inserting the sensor, take care the O-ring not to be damaged.
Rear Wheel Speed Sensor Components and Components Location
Components 1. Rear wheel speed sensor 2. Rear wheel speed sensor cable ...

Yaw-rate and G Sensor Description and Operation
Description When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electroniclly by the vibration change of plate fork inside the yaw rate sensor. ...

See also:

High Pressure Fuel Pump Repair procedures
Removal     In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure f ...

26 Brake Control Solenoid Valve(26/B_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

Heated Oxygen Sensor (HO2S) Troubleshooting
Wave Form ...

Categories

Hyundai Azera Manuals


© 2011-2024 Copyright www.hgmanual.com