Hyundai Equus Manuals

Hyundai Azera: Heated Oxygen Sensor (HO2S) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Azera 2011-2024 Service ManualHyundai Azera: Heated Oxygen Sensor (HO2S) Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Engine Control/Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 3 and 4.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the connector (A), and then remove the sensor (B).
   
Note that the SST (Part No.: 09392-2H100) is useful when removing the heated oxygen sensor.
[Bank 1/Sensor 1]

[Bank 1/Sensor 2]

[Bank 2/Sensor 1]

[Bank 2/Sensor 2]

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
   
•
DON’T use a cleaner, spray, or grease to sensing element and connector of the sensor because oil component in them may malfunction the sensor performance.
•
Sensor and its wiring may be damaged in case of contacting with the exhaust system (Exhaust Manifold, Catalytic Converter, and so on).
1.
Installation is reverse of removal.
Heated oxygen sensor installation:
35.3 ~ 45.1 N.m (3.6 ~ 4.6 kgf.m, 26.0 ~ 33.3 lb-ft)
Heated Oxygen Sensor (HO2S) Schematic Diagrams
Circuit Diagram ...

Rail Pressure Sensor (RPS) Description and Operation
Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in ...

See also:

Opening the fuel filler lid
The fuel filler lid must be opened from inside the vehicle by pushing the fuel filler lid opener button. If the fuel filler lid will not open because ice has formed around it, tap lightly or push o ...

Seat Belt Pretensioner (BPT) Repair procedures
Removal 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Left side - Remove the seat belt lower anchor cover (A). After loosening the ...

Mode Control Actuator Description and Operation
Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select ...

Categories

Hyundai Azera Manuals


© 2011-2024 Copyright www.hgmanual.com