Hyundai Equus Manuals

Hyundai Azera: Heater Core Repair procedures - Heater - Heating,Ventilation, Air Conditioning - Hyundai Azera 2011-2024 Service ManualHyundai Azera: Heater Core Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Heating,Ventilation, Air Conditioning / Heater / Heater Core Repair procedures

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/ recycling/ charging station.
3.
When the engine is cool, drain the engine coolant from the radiator.
4.
Remove the heater & blower assembly.
(Refer to Heater - "Heater Unit")
5.
Remove the blower unit (B) from heater unit after loosening 3 screws.

6.
Loosen the mounting screw and then remove the heater core cover (A).

7.
Remove the heater core (A) from heater unit.

   
•
Be careful that the inlet and outlet pipe are not bent during heater core removal / installation.
8.
Installation is the reverse order of removal
   
-
If you're installing a new evaporator, add refrigerant oil (ND-OIL8).
-
Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage.
-
Immediately after using the oil, replace the cap on the container, and seal it to avoid moisture absorption.
-
Do not spill the refrigerant oil on the vehicle ; it may damage the paint ; if the refrigerant oil contacts the paint, wash it off immediately
-
Apply sealant to the grommets.
-
Make sure that there is no air leakage.
-
Charge the system and test its performance.
-
Do not interchange the inlet and outlet heater hoses and install the hose clamps securely.
-
Refill the cooling system with engine coolant
Heater Unit Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/ recycling/ charging station. 3. When the engine is cool, drain the engine coola ...

Evaporator Core Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/ recycling/ charging station. 3. When the engine is cool, drain the engine coola ...

See also:

Multimedia Jack Repair procedures
Removal 1. Remove the center fascia tray. (Refer to Body - "Floor Console Assembly") 2. Disconnect the connectors (A) from center fascia tray. 3. Remove the multimedia jack (B) from the c ...

Front Stabilizer Bar Repair procedures
Replacement 1. Remove the front wheel & tire (A). Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     • Be careful not to damage to the hub b ...

Output Speed Sensor Specifications
Specifications ? Type: Hall effect sensor Operation condition [°C(°F)](-40~150) -40~302Air gap(mm)in.(0.8~1.25) 0.032~0.049Output voltageHigh1.18~1.68Low0.59~0.84 ...

Categories

Hyundai Azera Manuals


© 2011-2024 Copyright www.hgmanual.com