Removal |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the roof trim.
|
3. |
Disconnect the connector (A) of high mounted stop lamp. |
4. |
Remove the high mounted stop lamp (B) after removing the bolts (3EA) and a clip. |
Installation |
1. |
Install the high mounted stop lamp to the roof trim. |
2. |
Install the roof trim. |
Fuel Pressure Regulator Repair procedures
Removal
1.
Remove the fuel pump.
(Refer to Fuel Delivery System - “Fuel Pump”)
2.
Disconnect the electric pump wiring connector (A) and the fuel sender connector (B).
3.
Remove the cushi ...
ETC (Electronic Throttle Control) System Repair procedures
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Throttle ...
Description and Operation
Description
Windshield deicer system prevent windshield wiper from
freezing in the winter season. It consists of deicer in the lower part
of windshield, switch and relay. IPM receives an input ...