Removal |
In case of removing the high pressure fuel pump, high
pressure fuel pipe, delivery pipe, and injector, there may be injury
caused by leakage of the high pressure fuel. So don’t do any repair
work right after engine stops.
|
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”)
|
3. |
Remove the pump foam (A). |
4. |
Disconnect the fuel pressure control valve connector (A) and the fuel feed tube quick-connector (B). |
5. |
Remove the intake manifold.
|
6. |
Remove the injector foam (A). |
7. |
Remove the high pressure fuel pipe.
|
8. |
Remove the installation bolts (A), and then remove the high pressure fuel pump (B) from the cylinder head assembly.
|
Installation |
|
|
|
|
|
|
|
|
1. |
Installation is reverse of removal.
|
Panoramaroof Motor Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the roof trim.
(Refer to Body - "Roof Trim Assembly")
3.
Disconnect the panoramaroof motor (A) connector.
4.
Gro ...
Rear Door Latch Repair procedures
Replacement
1.
Remove the rear door module.
(Refer to Rear Door - "Rear Door Module")
2.
Disconnect the rear door latch connector (A).
3.
Remove the rear door latch assembly (A).
4.
I ...
Oil Cooler Components and Components Location
Components
1. Radiator2. Radiator mounting bracket3. Radiator cap4. Drain plug5. Mounting insulator
...