Hyundai Azera: Hood Latch Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Repair procedures

Replacement

1.	Remove the front bumper cover. (Refer to Front Bumper - "Front Bumper Cover")

2.	Detach the clips, then remove hood latch cover (A).

3.

Remove the hood latch (A) mounting bolts.

Tightening torque :

7.8 ~ 11.8N.m (0.8 ~ 1.2kgf.m, 5.8 ~ 8.7 lb-ft)

4.	Disconnect the hood latch cable (A) and remove the hood latch (B).

5.

Installation is the reverse of removal.

•	Make sure the hood latch cable is connected properly.

•	Make sure the hood locks/unlocks and opens/closes properly.

•	Adjust the latch alignment.

Hood Latch Components and Components Location

Component Location 1. Hood latch ...

Trunk Lid

...

See also:

Troubleshooting
Trouble Symptom Charts Trouble Symptom 1 Trouble Symptom 2 Trouble symptomProbable causeRemedyThe set vehicle speed varies greatly upward or downward"Surging" (repeated alternating acceleration ...

Inhibitor Switch Specifications
Specifications ? Type: Combination of output signals from 4 terminals Power supply (V)12Output typeCombination of output signals Signal Code Table PP-RRR-NNN-DDSignal 112V12V00000Signal 20 ...

Front Seat Shield Inner Cover Repair procedures
Replacement • Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface. • Take care not to bend or scratch the trim and pan ...

Categories

Hyundai Azera Manuals

© 2011-2024 Copyright www.hgmanual.com