Removal |
1. |
Remove the negative (-) battery terminal. |
2. |
Remove the driver seat in the car.
|
3. |
Remove the IMS module (A) after loosening 3 screws in the bottom of seat. |
4. |
Disconnect the IMS module connector (A) and then remove the IMS module (B). |
Installation |
1. |
Install the IMS module after reconnecting the connector. |
2. |
Install the driver seat.
|
Wipers & Washers
...
Power Out Side Mirror Switch Components and Components Location
Component
...
Intake Air Temperature Sensor (IATS) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and 4.
4.
Check that the resistance is within the speci ...