Hyundai Azera: Inhibitor Switch Description and Operation
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch Description and Operation
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch Description and Operation
| Description |
Inhibitor Switch monitors the lever's position(PRND) and is used to control gear setting signals.
SS-B Solenoid Valve(ON/OFF) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valver connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Inhibitor Switch Specifications
Specifications
? Type: Combination of output signals from 4 terminals
Power supply (V)12Output typeCombination of output signals
Signal Code Table
PP-RRR-NNN-DDSignal 112V12V00000Signal 20 ...
See also:
Components and Components Location
Components
1. Front pillar trim2. Center pillar upper trim3. Rear pillar trim4. Cowl side trim5. Center pillar lower trim6. Front door scuff trim7. Rear door scuff trim
...
Troubleshooting
Troubleshooting
Ignition System
SymptomSuspect areaRemedyEngine will not start or is hard to start (Cranks OK)Ignition lock switchInspect ignition lock switch, or replace as requiredIgnition coilI ...
Crankshaft Position Sensor (CKPS) Specifications
Specification
ItemSpecificationCoil Resistance (?)774 ~ 946 [20°C(68°F)]Air Gap (mm)0.5 ~ 1.5
...
Categories
Hyundai Azera Manuals
© 2011-2024 Copyright www.hgmanual.com