Inspection |
|
1. |
Inspect DTC code. |
2. |
Inspect whether N setting matches.
|
3. |
Inspect shift cable separation.
|
4. |
Inspect whether connector is connected.
|
5. |
Inspect ground condition on reversing light circuit.
|
6. |
Inspect wiring connection on junction box power terminal and fuse lamp.
|
7. |
Inspect inhibitor switch signal.
|
Removal |
1. |
Make sure vehicle does not roll before setting room side
shift lever and Automatic Transaxle(AT) side manual control lever to "N"
position. |
2. |
Remove the battery and the battery tray.
|
3. |
Remove the air cleaner assembly.
|
4. |
Remove the shift cable mounting nut (B).
|
5. |
Disconnect the inhibitor switch connector (A). |
6. |
Remove the manual control lever (B) and the washer after removing a nut (A).
|
7. |
Remove the inhibitor assembly (A) after removing the bolts (2ea).
|
Installation |
1. |
Installation is the reverse of removal. |
Parking Brake Assembly Repair procedures
Removal
Parking Brake Shoe
1.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear tire and wheel.
3.
Remove the rear brake caliper and Rear disc brake.
(Refer ...
Tires and wheels
✽ NOTICE
It is permissible to add 3psi to the standard tire pressure specification
if colder temperatures are expected soon. Tires typically loose 1psi for every 12°F
temperature drop. If ...
Roller Blind Shoe Repair procedures
Replacement
1.
Remove the roof trim assembly.
(Refer to Roof Trim - "Roof Trim Assembly")
2.
Remove the movable glass.
3.
After loosening the mounting TORX screws, remove the roller blind ...