Inspection |
1. |
Ignition "OFF". |
2. |
Disconnect the intake actuator connector. |
3. |
Verify that the actuator operates to the recirculation position when connecting 12V to the terminal 3 and grounding terminal 7. |
4. |
Verify that the intake actuator operates to the fresh position when connecting in the reverse.
|
5. |
Check the voltage between terminals 5 and 6.
Specification
|
6. |
If the intake actuator is not operated well, substitute with a known-good intake actuator and check for proper operation. |
7. |
If the problem is corrected, replace the intake actuator. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad.
|
3. |
Disconnect the Intake actuator connector (A). |
4. |
Loosen the mounting screw and then remove the intake actuator (B). |
5. |
Installation is the reverse order of removal. |
Rail Pressure Sensor (RPS) Description and Operation
Description
Rail Pressure Sensor (RPS) is installed on the delivery pipe
and measures the instantaneous fuel pressure in the delivery pipe. The
sensing element (Semiconductor element) built in ...
Good braking practices
WARNING
Whenever leaving the vehicle or parking, always set the parking brake
as far as possible and fully engage the vehicle's transaxle into the P (Park)
position. Vehicles not fully eng ...
Fuel Shut Off Valve Repair procedures
Removal
1.
Lift the vehicle and support the fuel tank with a jack.
2.
Remove the nuts (A) from fuel tank.
3.
Disconnect the fuel filler hose (A).
4.
Remove the fuel shut off valve (A). ...