Hyundai Equus Manuals

Hyundai Azera: Knee Airbag (KAB) Module Repair procedures - Airbag Module - Restraint - Hyundai Azera 2011-2024 Service ManualHyundai Azera: Knee Airbag (KAB) Module Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the crash pad lower panel.
3.
After loosening the mounting nuts and then remove the knee airbag (A).

4.
Disconnect the knee airbag harness connector (A).

Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Connect the knee airbag connector.
4.
Tighten the knee airbag mounting nuts.

Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

5.
Install the crash pad lower panel.
6.
Install the crash pad side cover.
7.
Reconnect the battery negative cable.
8.
After installing the knee airbag, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Knee Airbag (KAB) Module Components and Components Location
Components ...

Airbag Module Disposal Description and Operation
Airbag Disposal Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those in a whole vehicle to be scrapped), the airbags or side airba ...

See also:

Camshaft Position Sensor (CMPS) Description and Operation
Description Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element. It is related with Crankshaft Position Sensor (CKPS) and detects the pisto ...

Air cleaner
...

Closing the hood
1. Before closing the hood, check the following: All filler caps in engine compartment must be correctly installed. Gloves, rags or any other combustible material must be removed from the engi ...

Categories

Hyundai Azera Manuals


© 2011-2024 Copyright www.hgmanual.com