Hyundai Equus Manuals

Hyundai Azera: Knock Sensor (KS) Description and Operation - Engine Control System - Engine Control/Fuel System - Hyundai Azera 2011-2024 Service ManualHyundai Azera: Knock Sensor (KS) Description and Operation

Description
Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. The two Knock Sensor (KS) are installed inside the V-valley of the cylinder block and senses engine knocking.
When knocking occurs, the vibration from the cylinder block is applied as pressure to the piezoelectric element.
When a knock occurs, the sensor produces voltage signal. The ECM retards the ignition timing when knocking occurs. If the knocking disappears after retarding the ignition timing, the ECM will advance the ignition timing. This sequential control can improve engine power, torque and fuel economy.

Camshaft Position Sensor (CMPS) Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal     • DON'T remove the camshaft position se ...

Knock Sensor (KS) Specifications
Specification ItemSpecificationCapacitance (pF)950 ~ 1,350Resistance (M?)4.87 ...

See also:

Underdrive Brake Control Solenoid Valve(UD/B_VFS) Specifications
Specifications Direct control VFS[UD/B] ? Control type : Normal low type Control Pressure [kpa (kgf/cm?, psi)] 500.14 ~ 9.81(5.1 ~ 0.1, 72.54 ~ 1.42)Current value(mA)50~850 Internal resis ...

ENGINE START/STOP button position
OFF To turn off the engine (START/RUN position) or vehicle power (ON position), press the ENGINE START/STOP button with the shift lever in the P (Park) position. When you press the ENGINE START/S ...

Positive Crankcase Ventilation (PCV) Valve Repair procedures
Removal 1. Disconnect the vapor hose (A). 2. Remove the PCV valve (B). Inspection 1. Insert a thin stick (A) into the PCV valve (B) from the threaded side to check that the plunger moves ...

Categories

Hyundai Azera Manuals


© 2011-2024 Copyright www.hgmanual.com