Removal |
[Knock Sensor #1 (Bank 1)] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Disconnect the knock sensor connector (A). |
3. |
Remove the intake manifold.
|
4. |
Remove the installation bolt (A), and then remove the sensor from the cylinder block. |
[Knock Sensor #2 (Bank 2)] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Disconnect the knock sensor connector (A). |
3. |
Remove the intake manifold.
|
4. |
Remove the installation bolt (A), and then remove the sensor from the cylinder block. |
Installation |
|
|
1. |
Installation is reverse of removal.
|
CVVT Assembly Description and Operation
Description
Continuous Variable Valve Timing (CVVT) system advances or
retards the valve timing of the intake and exhaust valve in accordance
with the ECM control signal which is calculated by ...
Front Door Latch Components and Components Location
Component Location
1. Front door latch
...
Description and Operation
Description
Communication network diagram
AbbreviationExplanationC_CANChassis Controller Area NetworkB_CANBody Controller Area NetworkMM_CANMulti media Controller Area NetworkSMKSmart Key ECUD ...