Removal |
1. |
Turm ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Remove the air duct (B) and air cleaner assembly (A). |
3. |
Disconnect the brake fluid level switch connector (B), and remove the reservoir cap. |
4. |
Remove the brake fluid from the master cylinder reservoir with a syringe.
|
5. |
Disconnect the brake tube (A) from the master cylinder by loosening the tube flare nut.
|
6. |
Remove the master cylinder (B) from the brake booster after loosening the mounting nuts (A).
|
Installation |
1. |
Installation is the reverse of removal. |
2. |
After installation, bleed the brake system.
(Refer to Brake system bleeding) |
Drive Belt Tensioner Repair procedures
Removal and Installation
1.
Remove the drive belt idler.
(Refer to Timing System - "Idler")
2.
Remove the drive belt auto tensioner (A).
Tightening torque
Bolt (B) :
81.4 ~ 85.3N.m (8.3 ...
Reservoir Tank Repair procedures
Removal and Installation
1.
Disconnect the over flow hose (A), and then remove the resorvior tank (B).
Tightening torque:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
2.
Installation ...
Vehicle certification label
The vehicle certification label attached on the driver’s (or front passenger’s)
side center pillar gives the vehicle identification number (VIN). ...