Removal and Installation |
1. |
Remove the water pipe.
(Refer to Cooling System - "Water Pipe") |
2. |
Remove the oil pressure switch (A).
|
3. |
Installation is in the reverse order of removal. |
Inspection |
1. |
Check the continuity between the terminal and the body with an ohmmeter.
If there is no continuity, replace the oil pressure switch. |
2. |
Check the continuity between the terminal and the body when
the fine wire is pushed. If there is continuity even when the fine wire
is pushed, replace the switch. |
3. |
If there is no continuity when a 50 kpa (7psi) is applied
through the oil hole the switch is operaing properly. Check for air
leakage. If air leaks, the diaphragm is broken. Replace it. |
Temperature Control Actuator Components and Components Location
Component Location
...
Using USB Mode
Playing/Pausing USB Files
Once a USB is connected, the mode will automatically start and begin playing
a USB file.
While playing, press the key to
pause and press again to play.
✽ NOTIC ...
Checking the amount of air conditioner refrigerant and compressor lubricant
When the amount of refrigerant is low, the performance of the air conditioning
is reduced. Overfilling also has a negative impact on the air conditioning system.
Therefore, if abnormal operation is ...