Inspection |
1. |
Check signal waveform of Input & output speed sensor using the GDS.
|
Removal |
1. |
Remove the battery and the battery tray.
|
2. |
Remove the under cover (A).
|
3. |
Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug.
(Refer to Hydraulic System - "Fluid") |
4. |
Remove the valve body cover (B) and eyebolt (A).
|
5. |
Remove the plate and the detent spring (A) after removing the bolt.
|
6. |
Remove the bolt (3ea) after disconnecting the solenoid valve connector (A) and the oil temperature sensor connector (B).
|
7. |
Remove the valve body assembly (A).
|
8. |
Disconnect the input & output speed sensor connector(A). |
9. |
Remove the input & output speed sensor (B) after removing the bolts(2ea).
|
Installation |
1. |
Installation is the reverse of removal. |
After replacement or reinstallation procedure of the output speed sensor, must perform procedures below.
|
Basic Mode Screen
(1) Mode Displays currently operating mode.
(2) Operation State From Repeat / Shuffle / Scan, displays the currently operating
function.
(3) Track Info Displays information about the cu ...
Windshield Deicer Repair procedures
Inspection
1.
Remove the cowl top cover.
(Refer to Windshield Wiper/Washer - "Front Wiper Motor")
2.
Disconnect the windshield deicer connector from the wiper motor linkage.
3.
Check for ...
Rheostat Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the passenger compartment juction box cover.
3.
Remove the crash pad side switch assembly (A) by pushing it through ju ...