Inspection |
1. |
Turn ignition switch OFF. |
2. |
Disconnect the solenoid valve connector. |
3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
4. |
Check that the resistance is within the specification. |
Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to Hydraulic System - "Valve Body") |
Purge Control Solenoid Valve (PCSV) Schematic Diagrams
Circuit Diagram
...
Cowl Top Cover Components and Components Location
Component Location
1. Cowl top cover
...
Schematic Diagrams
Circuit Diagram
...