Removal |
1. |
Remove the front bumper.
|
2. |
Pull out the front sensor (A) from the sensor holder by opening the sensor holder out. |
3. |
Disconnect the connector from the front sensor. |
1. |
Remove the rear bumper.
|
2. |
Pull out the rear sensor (A) from the sensor holder by opening the sensor holder out. |
3. |
Disconnect the connector from the rear sensor. |
Installation |
1. |
Install the parking assist sensor to the bumper. |
2. |
Connect the connector. |
3. |
Install the corresponding bumper. |
Operation in foreign countries
If you are going to drive your vehicle in another country, be sure to:
Observe all regulations regarding registration and insurance.
Determine that acceptable fuel is available.
...
Rear Door Window Glass Repair procedures
Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
After loosening the mounting screws, then remove the rear door frame rear garnish (A).
3.
Loosen the r ...
Side Airbag (SAB) Module Description and Operation
Description
The Side Airbags (SAB) are installed inside the front seat
and protects the driver and passenger from danger when side crash
occurs. The SRSCM determines deployment of side airbag b ...