Removal |
1. |
Raise the vehicle, and make sure it is securely supported. |
2. |
Remove the rear tire and wheel. |
3. |
Remove the rear brake caliper and Rear disc brake.
(Refer to "Rear disc brake removal") |
4. |
Remove the parking brake cable (B), after removing the fixing clip (A). |
5. |
Remove the hub assembly.
|
6. |
Remove the adjuster assembly (B) and the lower return spring (A). |
7. |
Remove the upper return spring (C) operating lever assembly (D). |
8. |
Remove the shoe hold down pin (A) and the spring (B) by pressing and rotating the spring. |
9. |
Remove the brake shoes (C). |
Installation |
1. |
Install the shoe hold down pin (A) and spring (B) by pressing and rotating the spring. |
2. |
Install the operating lever assembly (D) and the upper return spring (C). |
3. |
Install the adjuster assembly (B) and the lower return spring (A). |
4. |
Install the hub assembly.
|
5. |
Install the parking brake cable (B), and then install the fixing clip (A). |
6. |
Install the rear brake disc, then adjust the rear brake shoe clearance.
|
7. |
Install the brake caliper assembly.
(Refer to "Rear brake installation") |
8. |
Install the tire and wheel, after installing the plug on the disc. |
9. |
If the parking brake shoe or the brake disc are replaced a newly one, perform the brake shoe bed-in procedure.
|
Specifications
Specification
ItemBulb Watt(W)TypeFrontHead lamp(High)55H7Head lamp(Low)55(General) /35(HID)H7/D1SPosition lampLEDLEDTurn signal lamp21HY21WFog lamp35H8Side markerLEDLEDRearStop lamp / Tail lampL ...
Emergency starting
Connect cables in numerical order and disconnect in reverse order.
Positive (+) battery terminal on
your vehicle
Positive (+) battery terminal on
the booster battery
Negative (-) battery ter ...
Vacuum crankcase ventilation hoses
Inspect the surface of hoses for evidence of heat and/or mechanical damage. Hard
and brittle rubber, cracking, tears, cuts, abrasions, and excessive swelling indicate
deterioration. Particular atten ...