Removal |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Remove the crash pad lower panel.
|
3. |
Remove the parking brake cable mounting nuts (A). |
4. |
Remove the parking brake cable adjusting nut(A) and the fixing clip(B), and then remove the parking brake pedal. |
5. |
Remove the floor console.
|
6. |
Remove the shift lever assembly.
|
7. |
Remove the parking brake cable (B) after removing the cable retainer (A). |
8. |
Remove the parking brake cable fixing clip (A) and bolts. And then remove the front parking brake cable. |
9. |
Raise the vehicle, and make sure it is securely supported. |
10. |
Remove the rear wheel & tire. |
11. |
Remove the parking brake cable (B) after removing the fixing clip (A). |
12. |
Loosen the parking brake cable bracket bolts and remove the rear parking brake cable. |
13. |
Installation is reverse of removal. |
Carry emergency equipment
Depending on the severity of the weather where you drive your vehicle, you should
carry appropriate emergency equipment. Some of the items you may want to carry include
tire chains, tow straps or ch ...
Instrument panel illumination
The instrument panel illumination intensity can be adjusted as follows:
Ignition switch in the ON position
Pushing the control switch up or down
The illumination intensity is shown on the ...
Thermostat Components and Components Location
Components
1. Water temperature control assembly2. Thermostat3. Water inlet fitting
...